DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
65
Parameter Description
• startup-config - Specifies to copy the startup configuration as the source.
• Image 1 - Specifies to copy firmware "Image 1" as the source.
• Image 2 - Specifies to copy firmware "Image 2" as the source.
• Configuration 1 - Specifies to copy "Configuration 1" as the source.
• Configuration 2 - Specifies to copy "Configuration 2" as the source.
Destination
Select the destination for the copy here. Options to choose from:
• running-config - Specifies to overwrite the running configuration with the
source.
• startup-config - Specifies to overwrite the start-up configuration with the
source.
• Image 1 - Specifies to overwrite "Image 1" with the source.
• Image 2 - Specifies to overwrite "Image 2" with the source.
• Configuration 1 - Specifies to overwrite "Configuration 1" with the source.
• Configuration 2 - Specifies to overwrite "Configuration 2" with the source.
Replace
Specifies to replace the current running configuration with the indicated
configuration file.
Click the Apply button to initiate the copy.
Click the Cancel button the discard the process.
After clicking the Boot File button, the following window will appear.
Figure 4-45 File System (Boot File) Window
The fields that can be configured in Boot File are described below:
Parameter Description
Boot Image Select the boot image here. Options to choose from are Image 1 and Image 2.
Boot Configuration Select the boot configuration here. Options to choose from are Configuration 1
and Configuration 2.
Click the Apply button to accept the changes made.
Click the Cancel button to discard the changes made.
To Next Page
Loading...
