DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
303
Appendix D - IETF RADIUS Attributes Support
Remote Authentication Dial-In User Service (RADIUS) attributes carry specific authentication, authorization,
information, and configuration details for the request and reply. This appendix lists the RADIUS attributes currently
supported by the Switch.
RADIUS attributes are supported by the IETF standard and Vendor-Specific Attribute (VSA). VSA allows the vendor to
create an additionally owned RADIUS attribute. For more information about D-Link VSA, refer to Appendix C -
RADIUS Attributes Assignment on page 302.
IETF standard RADIUS attributes are defined in the RFC 2865 Remote Authentication Dial-In User Service (RADIUS),
RFC 2866 RADIUS Accounting, and RFC 2868 RADIUS Attributes for Tunnel Protocol Support, and RFC 2869
RADIUS Extensions.
The following table lists the IETF RADIUS Authentication Attributes supported by the D-Link Switch.
Number IETF Attribute
1 User-Name
2 User-Password
3 CHAP-Password
4 NAS-IP-Address
5 NAS-Port
6 Service-Type
7 Framed-Protocol
8 Framed-IP-Address
12 Framed-MTU
18 Reply-Message
24 State
26 Vendor-Specific
27 Session-Timeout
29 Termination-Action
30 Called-Station-ID
31 Calling-Station-ID
32 NAS-Identifier
60 CHAP-Challenge
61 NAS-Port-Type
64 Tunnel-Type
65 Tunnel-Medium-Type
77 Connect-Info
79 EAP-Message
80 Message-Authenticator
81 Tunnel-Private-Group-ID
85 Acct-Interim-Interval
87 NAS-Port-ID
95 NAS-IPv6-Address
To Previous Page
Loading...
