DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
99
After clicking the Show Detail button, the following page will be available.
Figure 5-43 Link Aggregation (Channel Detail) Window
The fields that can be configured are described below:
Parameter Description
Description
Enter the description for the port channel here. This string can be up to 64
characters long.
Click the Apply button to accept the changes made.
Click the Delete Description button to delete the description for the port channel.
Click the Edit button to re-configure the specific entry.
Click the Back button to return to the previous page.
L2 Multicast Control
IGMP Snooping
Internet Group Management Protocol (IGMP) snooping allows the Switch to recognize IGMP queries and reports sent
between network stations or devices and an IGMP host.
IGMP Snooping Settings
In order to use IGMP Snooping it must first be enabled for the entire Switch under IGMP Global Settings at the top of
the window. You may then fine-tune the settings for each VLAN by clicking the corresponding Edit button. When
enabled for IGMP snooping, the Switch can open or close a port to a specific multicast group member based on IGMP
To Next Page
Loading...
