DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
17
Error Disable Settings
This window is used to display and configure the recovery from the Error Disable causes and to configure the recovery
interval.
To view the following window, click System > Port Configuration > Error Disable Settings, as shown below:
Figure 3-7 Error Disable Settings Window
The fields that can be configured for Error Disable Trap Settings are described below:
Parameter Description
Asserted
Specifies to enable or disable notifications for entering into the error-disabled
state.
Cleared
Specifies to enable or disable notifications for exiting from the error-disabled state.
Notification Rate
Enter the notification rate value here. This sets the number of traps per minute.
The packets that exceed the rate will be dropped. The range is from 0 to 1000.
The default value (0) indicates that an SNMP trap will be generated for every
change of the error disabled state.
Click the Apply button to accept the changes made.
The fields that can be configured for Error Disable Recovery Settings are described below:
Parameter Description
ErrDisable Cause Select the error disabled cause here. Options to choose from are Port Security,
Storm Control, Dynamic ARP Inspection, DHCP Snooping, and Loopback
Detect.
State
Select to enable or disable the error disabled recovery feature here.
Interval
Enter the time, in seconds, to recover the port from the error state caused by the
specified module. The range is from 5 to 86400.
Click the Apply button to accept the changes made.
To Next Page
Loading...
