D-Link DGS-1250 Series - Port Trust State and Mutation Binding

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
144
The fields that can be configured are described below:
Parameter Description
Mutation Name
Enter the DSCP mutation map name here. This name can be up to 32 characters
long.
Input DSCP List
Enter the input DSCP list value here. This value must be between 0 and 63.
Output DSCP List
Enter the output DSCP list value here. This value must be between 0 and 63.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Port Trust State and Mutation Binding
This window is used to display and configure the port trust state and mutation binding settings.
To view the following window, click QoS > Advanced Settings > Port Trust State and Mutation Binding, as shown
below:
Figure 7-8 Port Trust State and Mutation Binding Window
The fields that can be configured are described below:
Parameter Description
From Port - To Port
Select the range of ports that will be used for this configuration here.
Trust State Select the port trust state option here. Options to choose from are CoS and
DSCP.
DSCP Mutation Map Select and enter the DSCP mutation map name used here. This name can be up
to 32 characters long.
Select the None option to not allocate a DSCP mutation map to the port(s).
Click the Apply button to accept the changes made.