DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
265
Click the Boot File button to configure the bootup image and configuration file settings.
Click the c: hyperlink to navigate the C: drive
After clicking the c: hyperlink, the following window will appear.
Figure 14-15 File System (c:) Window
Click the Go button to navigate to the path entered.
Click the Previous button to return to the previous window.
Click the Copy button to copy a specific file to the Switch.
Click the Boot File button to configure the bootup image and configuration file settings.
Click the Delete button to remove a specific file from the file system.
After clicking the Copy button, the following windows will appear.
Figure 14-16 File System (Copy) Window
The fields that can be configured are described below:
Parameter Description
Source
Select the source for the copy here. Options to choose from:
• startup-config - Specifies to copy the startup configuration as the source.
• Image 1 - Specifies to copy firmware "Image 1" as the source.
• Image 2 - Specifies to copy firmware "Image 2" as the source.
• Configuration 1 - Specifies to copy "Configuration 1" as the source.
• Configuration 2 - Specifies to copy "Configuration 2" as the source.
Destination
Select the destination for the copy here. Options to choose from:
• running-config - Specifies to overwrite the running configuration with the
source.
• startup-config - Specifies to overwrite the start-up configuration with the
source.
• Image 1 - Specifies to overwrite "Image 1" with the source.
• Image 2 - Specifies to overwrite "Image 2" with the source.
To Next Page
Loading...
