User's Manual
112
6.7 ANPR
An alarm is triggered when the detected vehicle meets detection rule.
The Device supports only ANPR through AI by Camera. Make sure that the vehicle recognition
parameters of camera are configured. For details, see the user's manual of the camera.
6.7.1 Enabling the Smart Plan
To use AI by Camera, you need to enable the corresponding smart plan first. For details, see "6.2.1
Enabling the Smart Plan".
6.7.2 Setting ANPR
Set the deployment time and alarm linkage actions for ANPR.
Procedure
Step 1 Log in to the PC client.
Step 2 Click on the upper-right corner and then click
Event
.
You can also click
Event
from the configuration list on the home page.
Step 3 Select a remote device on the device tree, and then select
Smart Plan
>
ANPR
.
The function is enabled by default and cannot be disabled.
Step 4 Click
Schedule
to select a schedule from the drop-down list.
The system triggers corresponding alarm actions only during the alarm deployment
period.
You can select an existing schedule from the
Schedule
drop-down list. You can also add a
new schedule.
Step 5 Click
Select
next to
Event Linkage
to set alarm actions.
Step 6 Click
Save
.
6.7.3 Live View of ANPR
View ANPR results under the
Live
tab.
6.7.3.1 Setting Attribute Display
Configure the display rule of ANPR results.
Prerequisites
Before using this function, make sure that view has been created. See "7.1.1 View Management" for
detailed information.
To Next Page
Loading...
Need help?
General
