User's Manual
51
Step 5 Click Add.
●
Click remote device IP address, username, password, SN, channel and port to change
corresponding information.
●
If system fails to add the remote device, see the reason on the
Status column to change
the remote device information and then click Retry to try to add again.
●
If a remote device is in exception due to network disconnection other reasons, it can
also be added. It comes online after the exception is resolved.
Step 6 Click
Continue to add or Finish.
●
Click
Continue to add, device goes back to the Smart Add page to add more remote
device.
●
Click
Finish to complete adding remote device process. You can view the newly added
remote device information on the device list.
5.4.2.2 Manual Add
Step 1 Click , and then select DEVICE.
Step 2 Click and then select Manual add.
Step 3 Click Add Device.
Figure 5-18 Add device
Step 4 Set parameters and then click OK.
To Next Page
Loading...
