User's Manual
271
Step 7 Click Save.
8.4.3.2 Offline Alarm
When the remote device and the IVSS are disconnected, system can trigger an alarm.
Step 1 Click , or click on the configuration page, and then select
EVENT.
Step 2 Select a remote device in the device tree on the left.
Step 3 Select Device Offline > Device Offline.
Figure 8-63 IPC offline
Step 4 Click to enable offline alarm.
The device offline alarm is enabled by default. You can skip this step.
Step 5 Click
Deployment Time to select schedule from the drop-down list.
After setting deployment period, system triggers corresponding operations when there is
a device offline alarm in the specified period.
●
Click
View Schedule to view detailed schedule settings.
●
If the schedule is not added or the added schedule does not meet actual needs, click
Add Schedule. See "8.8.4 Schedule" for detailed information.
Step 6 Click Actions to set alarm actions. See "8.4.1 Alarm Actions" for detailed information.
Step 7 Click Save.
8.4.3.3 IPC External Alarm
Set IPC alarm input event, so that when there is an alarm input to the IPC, IPC uploads the alarm to
the Device. If the camera has multiple IO channels, you can set the alarm input event for each of
them as you might need.
Step 1 Click , or click on the configuration page, and then select
EVENT.
Step 2 Select a remote device in the device tree on the left.
Step 3 Select External Alarm > IO1.
To Next Page
Loading...
Need help?
General
