User's Manual
222
type.
â—‡
Read/Write: One can read, edit, add, and delete data on this disk.
â—‡
Read Only: One can only read data on this disk.
8.4.1.3.2 iSCSI Management
Set up the network disk through iSCSI and map the network disk to the Device so that the Device
can use the network disk for storage.
Make sure that service has been enabled on the iSCSI server and the server has provided the shared
file directory.
Procedure
Step 1 Log in to the PC client.
Step 2 Click on the upper-right corner and then click
Storage
.
You can also click
Storage
from the configuration list on the home page.
Step 3 Select
Storage Resource
>
Network Disk
>
iSCSI Management
.
Step 4 Click
Add
.
Figure 8-53 Add iSCSI
Step 5 Set parameters.
Table 8-25 Network disk parameters
Parameter Description
IP Address Enter the IP address of the iSCSI server.
Port Enter the port number of the iSCSI server. It is 3260 by default.
Anonymous
Click to enable anonymous login. If iSCSI server has no permission
limitation, you can log in to the server without entering the password
and username.
Username
If permission is required to access the shared file directory on the iSCSI