User's Manual
316
Figure 8-117 Time
Step 2 Set parameters.
Table 8-40 System parameters description
Time
Set system date and time. You can set manually or set device to
synchronize time with the NTP server.
●
: Select
and then set the actual date
and time in the following two ways.
◇
Click , and then set the time and date in the calendar.
◇
Click
to synchronize device time with your PC.
●
Sync with the Internet Time Server
: Select the checkbox, enter NTP
server IP address or domain, and then set
.
Time and Date
Format
Set time and date display format.
Time Zone Set device time zone.
Auto Time
Synchronization
After enabling this function, IVSS detects system time of remote device
once in every interval. When time of remote device is inconsistent with
IVSS time, IVSS will calibrate the time of remote device automatically.
Step 3 (Optional) Set DST.
DST is a system to stipulate local time, in order to save energy. If the country or region
where the device is located follows DST, you can enable DST to ensure that system time is
correct.
To Next Page
Loading...
Need help?
General
