User's Manual
50
Figure 5-11 Access management
Step 4 Under the
Quick Add
tab, click
Start Search
.
The search results are displayed.
To filter the search results, you can click .
Step 5 Select an uninitialized remote device and then click
Initialize
.
Click next to
Initialization Status
and then select
Uninitialized
to show uninitialized
remote devices only.
Step 6 Set the password and linked email address for the remote device.
You can skip this step if you keep
Using current device password and password
protection information
enabled as default. The remote device automatically uses the
current admin password and email address of the Device.
1) To manually configure the password, disable
Using current device password and
password protection information
.
2) Enter and confirm the password, and then click
Next
.
3) Set an email address, and then click
Next
.
You can use the email address to reset the password of the remote device if you forget
the password.
Step 7 Set the IP address of the remote device and then click
Next
.
●
When there is a DHCP server on the network, select
DHCP
, and the remote device gets
dynamic IP address automatically. You do not need to enter IP address, subnet mask
and gateway.
●
If you select
Static
, enter static IP address, subnet mask, default gateway and
incremental value.
To Next Page
Loading...
Need help?
General
