Danfoss FC 300 Design Guide

FC 300 Design Guide
How to Program
Process block: Made up of a data block of four
bytes (2 words) and contains:
- Control word and reference value (from
master to slave)
- Status word and present output frequency
(from slave to master)
Text block is used to read or write texts
via the data block.
Parameter commands and responses (AK)
*
default setting ()display text []value for use in communication via serial communication port
272
MG.33.B
6.22 - V LT is a registered Danfoss trademark

Danfoss FC 300 Specifications

General

Enclosure	IP20
Approvals	cUL, UL, CE
EMC filter	Built-in
Communication Options	CANopen, PROFIBUS DP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Output Voltage	0-100% of supply voltage