Datalogic DS8100 User Manual

Fieldbus
Reference Manual 125
Digital Output Lines
Control Output 1
This parameter is configurable only if Digital Output 1 Use is set to Profibus/
Profinet. Select Disable or Enable from the drop-down list. If enabled, it allows the
Fieldbus Master to drive the Scanner Master or SC5000 Controller Output 1 via bit 0
in Byte 0 (first byte) of the Output Area.
Control Output 2
This parameter is configurable only if Digital Output 2 Use is set to Profibus/
Profinet. Select Disable or Enable from the drop-down list. If enabled, it allows the
Fieldbus Master to drive the Scanner Master or SC5000 Controller Output 2 via bit 1
in Byte 0 (first byte) of the Output Area.
3. When you have finished making changes, click Update All to save all pend-
ing changes, click Reset All
to revert to all previously saved values, and click
Reset Page to revert to previous saved values on the current page.

Datalogic DS8100 Specifications

General

Brand	Datalogic
Model	DS8100
Category	Barcode Reader
Language	English