Datalogic DS8100 User Manual

Troubleshooting
254 DS8110 Barcode Scanner
83
Laser Fail-
ure
Error
Scanner has a
la
ser failure.
- There is no
la
ser light
emitted from
the scanner
- The mirror
wheel motor
may still be
spi
nning, how-
ever, the motor
speed may be
out of range at
which time the
scanner will
turn off the
laser light.
- Hold your hand
in
front of the
scanner to deter-
mine if the laser
is o
n.
This is an internal
fail
ure and is not
field serviceable.

- Replace scanner.
130
Encoder
Timeout
Warn-
ing
No encoder
(t
achometer) is
detected in
specified time.
The Encoder
signal provides
the scanner
with belt speed
and other track-
ing information.
This error will
o
nly occur when
the scanner is in
the PackTrack
mode.
- The scanner
may experi-
ence an
in
crease in no-
reads.
- The scanner
may star
t
missing the
transmit point.
- Confirm that
the belt is run-
ning.
- Make sure the
encoder
(t
achometer)
wheel is making
a firm contact
with the con-
veyor.
- Check the
Global Settings
|
Diagnostics |
Encoder Timeout
setting to con-
firm that it is not
se
t too low (See
“Diagnostics” on
page 159 ).
- Adjust the
encoder (tachome-
ter) mounting.
- Adjust the
En
coder Timeout
setting (See “Diag-
nostics” on
page 159 ).
131
Input 1
Fa
ilure
Error
The Primary PS
(
photoelectric
sensor) Input is
stuck in the
active state
(PackTrack
Mode).
- The scanner
wi
ll not go into
trigger.
- No data will
be
transmitted
to the Host.
- Check the
alignment of the
photoelectric
sensor.
- Check the
f
unctionality of
the photoelectric
sensor.
- Realign the pho-
toelectric sensor.
- Replace the pho-
toelectric sensor.
Error
Code
Descrip
-
tion
Sever-
ity
Explanation Symptom Troubleshooting Action required

Datalogic DS8100 Specifications

General

Brand	Datalogic
Model	DS8100
Category	Barcode Reader
Language	English