Datalogic DS8100 User Manual

Error Codes and Resolutions
Reference Manual 255
132
No Phase
Erro
r
Error
No Phase "time-
out" is exceeded
(On-Lin
e and
PackTrack
Mode).
- Trigger must
b
e identified
within a speci-
fied time.
133
Input 2
Failure
Error
Secondary PS
(photoelectric
sensor
) Input
Failure Stuck
Active (Pack-
Track Mode).
- The scanner
will n
ot go into
trigger.
- No data will
be tr
ansmitted
to the Host.
- Check the
ali
gnment of the
photoelectric
sensor.
- Check the
func
tionality of
the photoelectric
sensor.
- Realign the pho-
toelectric sensor.
- Replace the pho-
toelectric sensor.
135
Encoder
Failure
Error
Phase input
(t
rigger source)
is activated
while encoder
(tachometer) is
stopped (Pack-
Track Mode).
- No data will
be tr
ansmitted
to the host.
- Scanner(s)
will n
ot read
any barcodes.
- System
re
ceives trig-
ger cycle when
no
encoder sig-
nal is present.
- Check Diag-
nostics | Monitor
to see if
the
scanner is
reporting a con-
veyor speed (See
sect
ion “Diag-
nostics | Moni-
tor” on page 177
).
- Make sure the
en
coder
(tachometer)
wheel is making
a firm contact
with the con-
veyor.
- Adjust, realign, or
replace the encoder
(t
achometer).
157
SD Card
Failure
Error
SC5000 - SD
car
d cannot be
accessed. The
SD card con-
tains the
backup files. It
also con
tains a
copy of the
scanners appli-
cation software.
This failure is
onl
y in the
SC5000.
- Unit will not
backup
or
restore the
parameters.
Try to save the
pa
rameters from
the SC5000 to
the SD card (see
SC5000 System
Controller Refer-
ence Manual).
- Confirm that the
SD
card is seated
properly in the
SC5000.
- Replace SD card
(see
SC5000 System
Controller Refer-
ence Manual).
Error
Co
de
Descrip-
tion
Sever-
ity
Explanation Symptom Troubleshooting Action required

Datalogic DS8100 Specifications

General

Brand	Datalogic
Model	DS8100
Category	Barcode Reader
Language	English