Datalogic DS8100 User Manual

Error Codes and Resolutions
Reference Manual 257
193
Fieldbus
Config
Erro
r
Error
Error configur-
ing fieldbus
module.
- Unable to
communicate
to the module.
- Confirm that
the unit is not
communicating
to the host.
- Confirm that
the fi
eldbus
parameters are
configured prop-
erly (see section
“Digital I/O” on
page 156).
- Replace fieldbus
module.
195
Fieldbus
DHCP Err
or
Error
Profinet mod-
ule had a DHCP
er
ror.
- Unable to
ac
quire an IP
address.
- Confirm that
the unit is no
t
communicating
to the host.
- Confirm that
the fi
eldbus
parameters are
configured prop-
erly (see section
“Digital I/O” on
page 156).
- Replace fieldbus
module.
205
APD Tem-
perature
Erro
r
Error
APD Tempera-
ture sensor is
not workin
g. A
fluctuation in
the scanner's
temperature
can have an
adverse effect
on several inter-
nal functions of
the sc
anner.
The scanner
monitors the
temperature,
and if it is
erratic, this
error is posted.
- The scanner
m
ay experi-
ence an
in
crease in no-
reads.
- The scanner
m
ay start
missing the
transmit point.
1. Cycle power on
the sc
anner;
2. Wait until the
un
it has time to
cool down.
3. Restart the
scann
er and
monitor it to
determine
whether the
error reoccurs.
This is an internal
fa
ilure and is not
field serviceable.

- Replace scanner.
207
In Beam
Se
nsor
Error
Error
The scanner has
an in-the-beam
sensor
, which
provides timing
for the decod-
ing of barcodes.
The scanner
mon
itors this
signal, and
posts this error
if the signal is
sporadic or
missing.
- The scanner
st
ops reading
barcodes.
- Put the scan-
ner in the test
mode to te
st its
ability to read the
barcode (see
“Diagnostics |
Read Test” on
page 179).
This is an internal
fa
ilure and is not
field serviceable.

- Replace scanner.
Error
Code
Descrip-
tion
Sever-
ity
Explanation Symptom Troubleshooting Action required

Datalogic DS8100 Specifications

General

Brand	Datalogic
Model	DS8100
Category	Barcode Reader
Language	English