LED and Beeper Indicators ENTER/EXIT PROGRAMMING MODE
100
Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
Good Read LED Duration
This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 10 milliseconds to 2,550
milliseconds (0.001 to 2.55 seconds) in 100ms increments.
See page 313 in “References” for detailed instructions and examples fo
r setting this feature.
Select Good Read LED Duration Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the en
try string. You can then start again at the begin-
ning.
CANCEL
003 = Good Read LED stays on for 300 ms
Indicators are dimmed during sleep.
To Next Page
Loading...
