Scanning Features ENTER/EXIT PROGRAMMING MODE
102
Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
Stand Mode Triggered Timeout
This feature specifies the time to remain in Trigger Single mode after the trigger is pulled while
in Stand Mode.
This timeout is only used when the Scan Mode is configured as Stand Mode.
This feature is not applicable to the Gryphon L model.
Stand Mode Triggered Timeout = 0.5 Seconds
DEFAULT
Stand Mode Triggered Timeout = 1.5 Seconds
Stand Mode Triggered Timeout = 2 Seconds
Stand Mode Triggered Timeout = 3 Seconds
Stand Mode Triggered Timeout = 4 Seconds
Stand Mode Triggered Timeout = 6 Seconds
To Next Page
Loading...
