Scanning Features ENTER/EXIT PROGRAMMING MODE
104
Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
Stand Mode Sensitivity
Sets the sensitivity level for stand mode wakeup. Choices are low, medium and high.
Stand Mode Sensitivity = Low
Stand Mode Sensitivity = Medium
DEFAULT
Stand Mode Sensitivity = High
This feature is not applicable to the Gryphon L.
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 315 in “References” for descriptions of each feature
Select Scanning Active Time Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
005 = Scanning is active for 5 Seconds
To Next Page
Loading...
Need help?
General
