Datalogic Gryphon I GD4100 Product Reference Guide

ENTER/EXIT PROGRAMMING MODE
94 Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
Sleep Mode Timeout
This feature sets the amount of time that the reader will be idle before it enters into a low power
Sleep Mode. When in Sleep Mode the reader can no longer receive commands from the Host or
base station until it is woken up again by a trigger pull or being placed into a base station.
In order for the reader to enter Sleep Mode, the following cond
itions must be met:
Corded version (GD4100 only). RS-232 interface and trigger single, trigger multiple or trigger
pulse.
Mobile version (GM4100 only). Sleep state is allowed only on the handheld (not on the base)
when trigger single, trigger multiple or trigger pulse are set, and when the reader is not charging
the battery.
This feature is not applicable to the Gryphon Laser or Gryphon BT models
Sleep Mode Timeout = Disable
DEFAULT
Sleep Mode Timeout = 1 Second
Sleep Mode Timeout = 2 Seconds
Sleep Mode Timeout = 3 Seconds
$
Sleep Mode Timeout = 4 Seconds

Datalogic Gryphon I GD4100 Specifications

General

Brand	Datalogic
Model	Gryphon I GD4100
Category	Barcode Reader
Language	English