Customizing Configuration Settings
Product Reference Guide
33
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface barcode from the previous table, your installation requires you to
select options to further customize your reader, turn to the appropriate section for your interface
type in "Configuration Using Barcodes" starting on page 37.
• "RS-232 ONLY Interface" on page 41
• "RS-232/USB-Com Interfaces" on page 46
• "Keyboard Interface" on page 55
• "USB-OEM Interface" on page 67
• "IBM 46XX Interface" on page 69
• "Wand Emulation Interface" on page 73
Global Interface Features
See "Global Interface Features" on page 39 for settings configurable by all interface types.
Configuring Other Features
If your installation requires different programming than the standard factory default settings,
the following sections of this manual allow configuration of non-interface-specific settings you
might require:
Reading Parameters
:
Reading Parameters include programming for scanning, beeper and LED
indicators and other universal settings.
Code Selection
:
Includes options concerning the barcode label types (symbologies). These
settings allow you to enable/disable symbologies, set label lengths, require check digit, etc.
Wireless Features
:
Contains programming options for RF and Bluetooth models only.
Laser Features
:
Describes options and programming specific to laser models.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces
by scanning the following label.
Transmit Software Version
To Next Page
Loading...
Need help?
General
