To Next Page

To Previous Page

Setup

Gryphon™ I GD4100/GM4100/GBT 4100/L GD4300

Resetting the Product Configuration to Defaults

Restore Custom Defaults

If you aren’t sure what programming options are in your imager, or you’ve changed some

options and want to restore the Custom Default Configuration that may have been saved in the

scanner, scan the Restore Custom Default Configuration barcode below. This will restore the

custom configuration for the currently active interface.

Restore Custom Default Configuration

Custom defaults are based on the interface type. Configure the imager

for the correct interface before scanning this label.

Restore Factory Configuration

If you want to restore the Factory Configuration for your imager, scan either the Restore USA

Factory Configuration barcode or the Restore EU Factory Configuration barcode below. Both

labels restore the scanner configuration to the factory settings, including the interface type. The

USA label restores Label IDs to those historically used in the USA. The EU label restores Label

IDs to those historically used in Europe. The Label ID sets for USA and EU are shown in the

“Label ID” section on page 81 of this manual.

Restore USA Factory Configuration

Restore EU Factory Configuration

The programming items listed in the following sections show the factory default settings for

each of the menu commands.

Datalogic Gryphon I GD4100 Product Reference Guide

Other manuals for Datalogic Gryphon I GD4100