Product Reference Guide
17
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are present and undamaged. If
any damage occurred during shipment, contact Datalogic Technical Support. Information is
shown on page 10.
KEEP THE PACKAGING. Should the unit ever require se
rvice, it should be returned in its
original shipping container.
Setting Up the Reader
Depending on whether you are using a Corded or Mobile version of the Gryphon, follow the
steps provided in this section to connect and get your reader up and communicating with its
host.
1. Begin by Installing the Interface Cable (Cor
ded) or Connecting the B
ase Station (Mobile)
2. Go to Interface Selection and set the desired interface.
3. Configure Interface Settings (only if not using factory settings for that interface)
4. Go to Configuring Other Features (if modifications are needed from factory settings)
To Next Page
Loading...
Need help?
General
