To Next Page

To Previous Page

BT Pin Code

Product Reference Guide 281

BT Pin Code

After enabling Security Mode (see "BT Security Mode on page 280), specify whether you want to

set a 4-digit or a 16-digit PIN Code. See page 321

for detailed information and examples for

setting this feature.

Select PIN Code Length

DEFAULT

Select 4-character BT PIN Code

Select 16-character BT PIN Code

Set PIN Code

Determine the desired characters for the PIN code, then convert to hexadecimal using the

ASCII Chart on the inside back cover of this manual. See page 321 for detailed information and

examples for setting this feature.

Set 4-character BT Pin Code

DEFAULT

To configure this feature, scan the ENTER/EXIT PROGRAMMING

MODE bar code above, then the desired bar code , followed by

the digits from the Alphanumeric characters in Appendix D.

Keypad representing your desired character(s). End by scan-

ning the ENTER/EXIT bar code again.

Set 16-character BT PIN Code

CANCEL

Make a mistake? Scan the CANCEL barcode to abort and not

save

the entry string. You can then start again at the begin-

ning.

Datalogic Gryphon I GD4100 Product Reference Guide

Other manuals for Datalogic Gryphon I GD4100