Delem DA-65W - Page 119

V1108, 8.7
interpolated and offered.
The correction database is adjusted by entering new corrections during production.
When the database is enabled with this parameter, all new-entered corrections are
stored in the database.
When searching for similar bends, the control searches for bends that have the same
properties as the active bend. The following properties of a bend are compared:
- Material properties
- Thickness
- Die opening
- Die radius
- Punch radius
- Angle
The first five properties of a bend must be exactly the same as the active bend to start a
comparison. If the angle is the same as the angle of the active bend, the correction is
offered. If the angle of the active bend has a maximum difference of 10° with two
adjacent bends, a correction is interpolated from these two bends. If the resulting
correction has a difference of more than 5° with one of the two other bends, there will be
no correction offered.
Auto-computations edit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..AC
In the ‘data edit’ mode you can change the value of the programmed parameters. This
can also influence the value of other parameters. With this parameter you can choose to
have the other values automatically recomputed. Program ‘auto computations edit’ to 1.
There are three cases in which automatic computation can be used.
1. In case you change the value of the parameters ‘material type’ or ‘material thickness’
then the following parameters are automatically recomputed and changed by the
control:
- Force
- Decompression distance
- Crowning device setting
2. In case you change the value of the parameter ‘length’ then the following parameters
are automatically recomputed and changed by the control:
- Force
- Decompression distance
- Crowning device setting
- Z-axis position
3. In case you change the parameter ‘punch’ or ‘die’ and the height of the new punch or
new die is different AND ONLY in case the ‘bend method’ is ‘bottoming’ or ‘flattening’
then the following parameter is automatically recomputed and changed by the control:
- Y-axis position (‘bend position’)
(When the ‘bend method’ is ‘air bend’ (normal situation) the Y-axis position is calculated
in the automatic mode!)
If the automatic recomputation is switched off (default situation) then these parameters
stay the same. However, when you go to these parameters with the cursor keys the
recomputed value is displayed in the input row. When you press ‘enter’ the recomputed
value replaces the old value after all. So, you can choose to change the values.
X1X2 difference programming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..XX
0 = angular format
1 = projection method
When you have two independent X-axes (X1 and X2) and the option OP-X1X2 has been
installed, you can program the values for X1, X2 in a certain relation. This means that