Chapter 8 Option CardsMH300
8-40
Environment
Noise immunity
ESD (IEC 61800-5-1, IEC 6100-4-2)
EFT (IEC 61800-5-1, IEC 6100-4-4)
Surge Test (IEC 61800-5-1, IEC 6100-4-5)
Conducted Susceptibility Test (IEC 61800-5-1, IEC 6100-4-6)
Operation / Storage
Operation: -10–50º C (temperature), 90% (humidity)
Storage: -25–70º C (temperature), 95% (humidity)
Shock / Vibration
resistance
International standards:
IEC 61131-2, IEC 68-2-6 (TEST Fc) / IEC 61131-2 & IEC 68-2-27(TEST Ea)
Table 8-39
8-13-4 Installation
PROFIBUS DP Connector pin assignment
PIN PIN name Definition
1
6
5
9
Figure 8-87
1 - Not defined
2 - Not defined
3 Rxd / Txd-P Sending / receiving data P(B)
4 - Not defined
5 DGND Data reference ground
6 VP Power voltage – positive
7 - Not defined
8 Rxd / Txd-N Sending / receiving data N(A)
9 - Not defined
Table 8-40
8-13-5 LED Indicator Light & Troubleshooting
There are two LED indicators on the CMM-PD02: POWER LED and NET LED. POWER LED
displays the status of the working power. NET LED displays the connection status of the
communication.
POWER LED
LED status Indication Corrective Action
Green light is
ON
Working power in normal status. No action is required
OFF No power
Check if the connection between the CMM-PD02
and the AC motor drive is normal.
Table 8-41
NET LED
LED status Indication Corrective Action
Green light is
ON
Normal status No action is required
Red light is ON
The CMM-PD02 does not connect to
PROFIBUS DP bus.
Connect the CMM-PD02 to the PROFIBUS DP bus.
Red light
flashes
Invalid PROFIBUS communication
address
Set the PROFIBUS address of the CMM-PD02
between 1–125 (decimal)
Orange light
flashes
The CMM-PD02 fails to
communicate with AC motor drive.
Switch off the power and check whether the CMM-
PD02 is been installed correctly and connected
normally to the AC motor drive.
Table 8-42
To Next Page
Loading...
