EasyManua.ls Logo

Delta MH300 Series - 03 Analog Input; Output Parameters

Delta MH300 Series
1030 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 11 Summary of Parameter Settings
MH300
11-21
03 Analog Input / Output Parameters
Pr. Parameter Name Setting Range Default
03-00
AVI a
nalog input selection
0: No function
1: Frequency command
2: Torque command (torque limit in speed mode)
3: Torque compensation command
4: PID target value
5: PID feedback signal
6: Thermistor input value (PTC)
7: Positive torque limit
8: Negative torque limit
9: Regenerative torque limit
10: Positive / negative torque limit
11: PT100 thermistor input value
12: Auxiliary frequency input
13: PID compensation value
14: Tension PID feedback signal
15: Line speed
16: Reel diameter
17: Tension PID target value
18: Tension setting value
19: Zero-speed tension
20: Tension taper
1
03-01
ACI analog input selection
0
03-03 AVI analog input bias
-100.0
100.0%
0.0
03-04 ACI analog input bias
-100.0
100.0%
0.0
03-07
AVI positive / negative
bias mode
0: No bias
1: Lower than or equal to bias
2: Greater than or equal to bias
3: The absolute value of the bias voltage while serving
as the center
4: Bias serves as the center
0
03-08
ACI positive / negative
bias mode
03-10
Reverse setting when
analog signal input is
negative frequency
0: Negative frequency input is not allowed. The digital
keypad or external terminal controls the forward and
reverse direction.
1: Negative frequency input is allowed. Positive
frequency = run in forward direction; negative
frequency = run in reverse direction. The digital
keypad or external terminal control cannot switch the
running direction.
0
03-11 AVI analog input gain
-500.0
500.0%
100.0
03-12 ACI analog input gain
-500.0
500.0%
100.0

Table of Contents

Related product manuals