EasyManua.ls Logo

Delta MH300 Series - 14 Protection Parameters (2)

Delta MH300 Series
1030 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 11 Summary of Parameter Settings
MH300
11-61
14 Protection Parameters (2)
Pr. Parameter Name
Setting Range
Default
14-00
Extension card input
terminal selection (AI10)
0: No function
1: Frequency command
(in MH300 series, this function can be the torque limit
in torque control mode)
2: Torque command (torque limit in speed mode)
3: Torque compensation command
4: PID target value
5: PID feedback signal
6: PTC thermistor input value
7: Positive torque limit
8: Negative torque limit
9: Regenerative torque limit
10: Positive / negative torque limit
11: PT100 thermistor input value
13: PID compensation amount
0
14-01
Extension card input
terminal selection (AI11)
0
14-02 AI10 Analog input bias -100.0100.0% 0.0
14-03 AI11 Analog input bias -100.0100.0% 0.0
14-04
AI10 positive / negative
bias mode
0: No bias
1: Lower than or equal to bias
2: Higher than or equal to bias
3: The absolute value of the bias voltage while serving as
the center
4: Bias serves as the center
0
14-05
AI11 positive / negative
bias mode
0
14-06 AI10 analog input gain -500.0500.0% 100.0
14-07 AI11 analog input gain -500.0500.0% 100.0
14-08
AI10 analog input filter
time
0.0020.00 sec. 0.01
14-09
AI11 analog input filter
time
0.0020.00 sec. 0.01
14-10
ACI10 analog input 420
mA signal loss selection
0: Disable
1: Continue operation at the last frequency
2: Decelerate to 0 Hz
3: Stop immediately and display ACE
0
14-11
ACI11 analog input 420
mA signal loss selection
0
14-12
AO10 extension card
output terminal selection
0: Output frequency (Hz)
0
1: Frequency command (Hz)
14-13
AO11 extension card
output terminal selection
2: Motor speed (Hz)
0
3: Output current (rms)
4: Output voltage
5: DC bus voltage

Table of Contents

Related product manuals