Delta MH300 Series - Page 306

Chapter 11 Summary of Parameter Settings
MH300
11-47
Pr. Parameter Name Setting Range Default

09-84
Communication card
gateway address 1
(for EtherNet)
0–255 0

09-85
Communication card
gateway address 2
(for EtherNet)
0–255 0

09-86
Communication card
gateway address 3
(for EtherNet)
0–255 0

09-87
Communication card
gateway address 4
(for EtherNet)
0–255 0

09-88
Communication card
password (low word)
(for EtherNet)
0–99 0

09-89
Communication card
password (high word)
(for EtherNet)
0–99 0

09-90
Reset communication
card (for EtherNet)
0: Disable
1: Reset, return to default
0
09-91
Additional settings for the
communication card
(for EtherNet)
bit 0: Enable IP filter
bit 1: Enable internet parameters (1 bit).
When IP address is set, this bit is enabled. After
updating the communication card parameters, this
bit changes to be disabled.
bit 2: Enable login password (1 bit).
When you enter the login password, this bit is
enabled. After updating the communication card
parameters, this bit changes to be disabled.
0
09-92
Communication card
status (for EtherNet)
bit 0: Enable password.
When the communication card is set with a
password, this bit is enabled.
When the password is cleared, this bit is disabled.
0