Chapter 12 Description of Parameter Settings
MH300
19: External interrupt B.B. input (Base Block)
20: Warning output
21: Over-voltage
22: Over-current stall prevention
23: Over-voltage stall prevention
24: Operation source
25: Forward command
26: Reverse command
29: Output when frequency ≥ Pr.02-34
30: Output when frequency < Pr.02-34
31: Y-connection for the motor coil
32: ∆-connection for the motor coil
33: Zero speed (actual output frequency)
34: Zero speed include STOP (actual output frequency)
35: Error output selection 1 (Pr.06-23)
36: Error output selection 2 (Pr.06-24)
37: Error output selection 3 (Pr.06-25)
38: Error output selection 4 (Pr.06-26)
39: Position reached (Pr.10-19)
40: Speed reached (including STOP)
42: Crane function
43: Motor actual speed detection
44: Low current output (use with Pr.06-71–Pr.06-73)
45: UVW output electromagnetic valve ON / OFF switch
46: Outputs when master dEb acts
49: Homing action completed
50: Output control for CANopen
51: Output control for RS-485
52: Output control for communication cards
66: SO output logic A
67: Outputs when analog input level reached
68: SO output logic B
69: Maximum reel diameter reached
70: Empty reel diameter reached
71: Broken belt detection
72: Tension PID feedback error
73: Over-torque 3
74: Over-torque 4
Use this parameter to set the function of the multi-function terminals.
Summary of function settings
Take the normally open contact (N.O.) for example, ON: contact is closed, OFF: contact is open.
To Next Page
Loading...
