Chapter 13 Warning Codes|MH300
ID No.
Display Warning Name Description
8
Save error 2
(SE2)
Keypad COPY error 2: parameter writing error
Action and Reset
Action level
“SE2” warning occurs when writing the parameters incorrectly at the
time
you copy parameters to the drive. For example, you copy the new
firmware version with added parameters to the drive with old firmware
version.
Action time N/A
Warning setting parameter N/A
Reset method Manual reset
Reset condition Immediately reset
Record N/A
Cause Corrective Actions
Add new parameters to the
new firmware version.
SE2: In this stage, the copied data has been transmitted to the Slave.
The Slave compares and processes the copied data, and then save
data to the Data ROM. During the process, the data error (should be
attribution error) may occur, or the data cannot be saved to EEPROM. At
this time, the warning occurs.
It is suggested to check the status of Data ROM and remove the error
causes first.
If you cannot clear the error, please contact Delta.
Malfunction caused by
interference
Verify the wiring and grounding of the main cir
cuit, control circuit and the
encoder for effective anti-interference performance.
To Next Page
Loading...
