Delta MH300 Series - Page 777

Chapter 14 Fault CodesMH300
14-50
ID No. Display Fault Name Description
43
PG feedback loss
(PGF2)
Pr. 10-00 and Pr. 10-
02 is not set in the PG control
mode. When press “RUN” key, PGF2 fault occurs.
Action and Reset
Action condition Software detection
Action time Act immediately
Fault treatment parameter N/A
Reset method Manual reset
Reset condition Reset immediately
Record Yes
Cause Corrective Actions
Incorrect setting of encoder
parameter
Reset encoder parameters (Pr. 10-00 and Pr. 10-02)
Incorrect selection of the
control mode
Choose the correct control mode.