Delta MH300 Series - Page 923

Chapter 16 PLC Function ApplicationsMH300
16-60
API
BMOV
S D
n
Send all
15
P
bit device
Word device
16-bit command (7 STEP)
BMOV
Continuous
execution type
BMOVP
Pulse
execution type
32-bit command
－
－
－
－
Flag signal: none
X
Y
M
K
H
KnX
KnY
KnM
T
C
D
S
＊ ＊ ＊ ＊ ＊ ＊
D
＊ ＊ ＊ ＊ ＊
n
＊ ＊ ＊ ＊
Notes on operand usage:
n operand scope n ＝ 1 to 512

S: Initiate source device. D: Initiate destination device. n: Send block length.
 Sends t
he content of n registers starting from the initial number of the device
designated by S
to the n registers starting from the initial number of the device
designated by n; if the number of points referred to by n exceeds the range used
by that device, sends only points within the valid range.
 When X10=ON, sends the content of registers D0–D3 to the four registers D20–
D23.

When sending from designated bit devices KnX, KnY, and KnM, S and D must
have the same number of nibbles, which means n must be identical
for source
and destination.