Delta MH300 Series - Page 937

Chapter 16 PLC Function ApplicationsMH300
16-74
API
DEG
Convert diameter to angle
117
D
P
bit device
Word device
16-bit command
－
－
－
－
32-bit command (9 STEP)
DDEG
Continuous
execution type
DDEGP
Pulse
execution type
Flag signal: none
X
Y
M
K
H
KnX
KnY
KnM
T
C
D
S
＊ ＊ ＊
D
＊
Notes on operand usage:
R
efer to the function specifications table for each device in series
for the scope of device usage.

S: data source (diameter). D: results of transformation (angle).
 Uses the following formula to convert radians to an angle.
 Angle = Diameter × (180/π)
 When X0=ON, angle of the designated binary floating point number (D1, D0) in
radians is converted to an angle and stored in (D11, D10), with the content
consisting of a binary floating point number.
X0
DDEG D0 D10