3
Print Operations
3-18 ineo+ 650/550/451
Hole punching
Holes can be punched into the printed document.
2
Reminder
The hole punch function is available only when the punch kit is installed on the optional finisher.
1 Click the Finish tab.
2 Select the "Punch" check box.
3 From the drop-down list, specify the number of punched holes.
2
Note
The hole-punch position changes according to the binding position specified from "Binding Direction".
Folding
You can specify to fold a printed document.
2
Reminder
The fold function is available only when the optional finisher or saddle stitcher on the finisher is installed.
1 Click the Finish tab.
2 Select the "Fold" check box.
3 From the drop-down list, specify the folding condition.
2
Note
The fold function cannot be specified when the staple, punch, or saddle stitch function is specified.
Specifying the output tray
You can specify the tray to which the printed document is output.
1 Click the Finish tab.
2 From the "Output Tray" drop-down list, specify the output tray.
Specifying the procedure for adjusting the binding position
You can specify the procedure for adjusting the binding position for duplex printing.
If "Prioritize Arranging Papers" is selected, all pages can be processed to a suitable quality by this machine
because the binding position is adjusted after all the print data is received. If "Prioritize Productivity" is
selected, the printing process is performed efficiently because the binding position is adjusted while the data
is printed simultaneously as it is being received.
If you want to increase the print efficiency, select "Prioritize Productivity". If the desired binding position and
width cannot be achieved, select "Prioritize Arranging Papers".
1 Click the Finish tab.
2 From the "Paper Arrangement" drop-down list, specify the processing method.
To Next Page
Loading...
