4.
Set the Z origin.
A
Close the front cover.
B
Press [ENTER/PAUSE].
C
Press [ ], [ ], [ ], and [ ] to move the end mill to the area above the workpiece.
Next, perform a small amount of cutting into the workpiece. Move to a location where cutting will not
cause any problems.
D
Hold down [SPINDLE] for one second or longer.
The spindle rotates.
SPINDLE
ON/OFF
E
Press [-Z] to lower the end mill to a location where the workpiece is cut by a slight
amount.
Workpiece
End mill
Using Various Tools
100
Chapter 5 Various Engraving Methods
To Next Page
Loading...
