C
Install the cutter holder.
While holding the spindle unit immobile with a wrench, tighten the cutter holder.
The cutter holder is reverse-threaded (that is, you turn it counterclockwise to tighten it). Be careful to
turn it in the correct direction.
Wrench
Spindle unit
Cutter holder
Turn counterclockwise
D
Attach a solid collet that ts the diameter of the cutter.
There are two types of solid collets. Use a solid collet that ts the diameter of the cutter.
For ø3.175 mm (0.125 in.)
For ø4.36 mm (0.17 in.)
(Optional item)
1 Temporarily tighten the solid collet.
Insert the solid collet into the spindle unit from below, then, while holding the spindle unit immobile
with a wrench, tighten temporarily.
Wrench
Spindle unit
Solid collet
Using Various Tools
107
Chapter 5 Various Engraving Methods
To Next Page
Loading...
