B
Press [ENTER/PAUSE].
C
Set the spindle rotation to "OFF."
1 Press [MENU/TOP] several times to display the following menu.
SETTINGS
OPERATING MODE
SPINDLE REVOLUTION ON
AUTO Z CONTROL OFF
012345678901234567 READY
2 Turn the [Dial] and select [SPINDLE REVOLUTION].
3 Press [ENTER/PAUSE].
4 Turn the [Dial] and select [OFF].
SETTINGS
OPERATING MODE
SPINDLE REVOLUTION OFF
AUTO Z CONTROL OFF
012345678901234567 READY
5 Press [ENTER/PAUSE] to conrm.
D
Set the automatic Z control to [ON].
1 Turn the [Dial] and select [AUTO Z CONTROL].
2 Press [ENTER/PAUSE].
3 Turn the [Dial] and select [ON].
* The [Depth] setting selected in the software is disabled.
SETTINGS
OPERATING MODE
SPINDLE REVOLUTION OFF
AUTO Z CONTROL ON
012345678901234567 READY
4 Press [ENTER/PAUSE] to conrm.
After the following message is displayed for three seconds, the previous screen appears again.
Please set the lock lever
at the 1 or 2 position.
012345678901234567 READY
Important: Accurately perform P. 92 "3. Set the lock lever." later in this procedure.
Using Various Tools
89
Chapter 5 Various Engraving Methods
To Next Page
Loading...
