- When changing an attachment, to avoid damaging the
hydraulic ttings switch off the engine and wait a minute
to discharge the pressure from the circuit. Always clean
the ttings before tting another attachment.
- Check the quick-t connections on the attachment circuits
daily to ensure they are clean, protected and in good condition.
- CAUTION -
Anyone using the machine who realises it is not functioning
properly or that it does not comply with safety regulations,
must immediately report this to the person in charge.
- PROHIBITION -
IT IS FORBIDDEN for the driver to carry out any repairs
or adjustments unless he or she has been specifically
trained to do so. The driver must keep the machine in
perfect working condition if entrusted to do so.
- PROHIBITION -
IT IS STRICTLY FORBIDDEN to attempt to start the ma-
chine by pushing or towing it. These operations can
cause serious damage to people and the gears.
- If the machine is used in low temperatures (-10°C), drain
the tanks and refill using lubricants, fuel and coolants
suitable for cold temperatures.
- CAUTION -
IT IS FORBIDDEN to use the machine in protected envi-
ronments such as reneries or explosive atmospheres.
Specic equipment exists for use in these types of envi-
ronments. Consult you dealer or agent.
- Ensure the service brakes and horn work properly.
- Slow down before making a turn.
- Always ensure you are in control of the machine and its
respective speed.
- Do not reverse over long distances.
- Brake gradually, do not brake sharply.
- Always remember that hydraulic steering is very sensitive to
steering wheel movements, steer gradually and smoothly.
- When the machine is loaded, never exceed 10 Km/h.
- It is forbidden to transport loads on roads. Any acces-
sories assembled on the machine must either feature
standard equipment or be disassembled.
- PROHIBITION -
IT IS STRICTLY FORBIDDEN to transport or lift people
with the machine, unless the machine is equipped to do
so and is certied to lift people.
- Comply with the indications regarding load programs.
- CAUTION -
Every time the machine is used, ensure any attachments
are correctly assembled and fastened onto their supports.
- CAUTION -
Before using the machine, always ensure the safety system
settings in the cab comply with the assembled accessory.
- The indications provided by the anti roll-over system
must be considered valid for machines in standard work
conditions, on level and solid ground with a functioning
and properly calibrated attachment. In any case, never
exceed the limit values in the load diagram.
- Never approach naked ames with the attachments.
- Never hoist loads harnessed with a single fork or with a plank.
- When rotating the turret, ensure it does not crash into
obstacles.
- When using on sloping ground, before raising the boom,
ensure the machine is perfectly levelled.
- When moving along longitudinal slopes:
Move forward and brake gently.
When moving without a load: ensure the forks or at
tachment are facing downhill.
When moving with a load: ensure the forks or
attachment are facing uphill.
- Ensure the rotation locking pin is not inserted before ro-
tating the turret.
- CAUTION -
THE MACHINE IS TYPE-APPROVED TO WORK ON 4
COMPLETELY OR PARTIALLY EXTENDED STABILISERS.
DO NOT USE THE MACHINE WITH ONLY 1, 2 OR 3 STABILISERS.
- CAUTION -
THE MACHINE IS INTENDED AS STABILISED WHEN ALL
4 TYRES ARE COMPLETELY RAISED OFF THE GROUND.
To Next Page
Loading...
