Placing loads in high places
1. Place the load in the carrying position in front of the pile.
2. Raise and extend the boom until the load is above the
pile. If necessary, advance the machine towards the pile
very slowly and with the utmost care.
3. Engage the parking brake and shift the gear selector to neutral,
4. Position the load horizontally and place on top of the pile, lo-
wer and retract the extensions to position the load correctly.
5. Release the forks by alternately retracting the extensions
and raising the boom; if possible reverse the machine
very slowly and with the utmost care.
- CAUTION -
Always comply with the centre of gravity of the load,
tilt the forks enough to ensure stability and to avoid
dropping the load when braking.
- PROHIBITION -
IT IS STRICTLY FORBIDDEN TO PICK UP A LOAD IF
THE MACHINE IS NOT LEVEL.
- CAUTION -
Never carry loads while the boom is raised and/or
extended.
To Next Page
Loading...
