Picking up a round load
- Tilt the forks forwards and extend the telescopic boom.
While inserting the forks under the load, turn the fork
holder plate backwards to allow the load to slide. If ne-
cessary, secure the load with wedges.
- CAUTION -
Always comply with the centre of gravity of the load,
tilt the forks enough to ensure stability and to avoid
dropping the load when braking.
- CAUTION -
Never carry loads while the boom is raised and/or
extended.
Handling loads and rotating the turret
- The same procedures for raising loads while the machi-
ne is aligned apply when the machine is rotated.
- Rotation must always take place while the boom is in
transport mode.
- Before rotating, enable the rear axle oscillation lock.
- PROHIBITION -
IT IS STRICTLY FORBIDDEN TO PICK UP A LOAD IF
THE MACHINE IS NOT LEVEL.
- CAUTION -
Always comply with the centre of gravity of the load.
- PROHIBITION -
IT IS STRICTLY FORBIDDEN TO ROTATE THE TURRET
WHILE THE BOOM IS RAISED AND/OR EXTENDED.
- CAUTION -
Never carry loads while the boom is raised and/or
extended.
To Next Page
Loading...
