Dynamic DX - Page 7

MT
7
7 DX programming...................................................113
7.1 Programming tools ......................................................................114
7.1.1 The Hand Held Programmer (HHP)........................... 114
7.1.1.1 HHP Technician Mode.................................................. 114
7.1.2 The PC-based Wizard program ................................ 115
7.1.2.1 Dongle versions.............................................................. 115
7.1.3 Programming accessories ordering information....116
7.2 Localised parameter storage.................................................... 117
7.3 Auto Download............................................................................ 118
7.4 Programming and testing a DX chair for stability................... 119
7.5 Retain the settings with a Master Remote replacement ......125
7.5.1 Replacement with the same type Master Remote125
7.5.2 Replacement with another type Master Remote .128
8 Testing ....................................................................130
8.1 Before testing................................................................................ 130
8.2 The testing procedure................................................................. 130
9 Diagnostics ............................................................133
9.1 Limp Mode.................................................................................... 133
9.2 Stuck Power Button...................................................................... 133
9.3 Out Of Neutral At Power Up (OONAPU)..................................134
9.4 Diagnostic tools............................................................................134
9.5 Battery warning conditions ........................................................ 135
9.6 Flash codes...................................................................................136
10 Appendices ...........................................................139
10.1 Intended Use and Regulatory Statement................................ 139
10.2 Maintenance................................................................................ 140
10.3 Warranty........................................................................................ 140
10.4 Safety and Misuse warnings....................................................... 141
10.5 Electromagnetic Compatibility (EMC)..................................... 143
10.6 Minimising emissions ....................................................................143
10.7 Environmental statement........................................................... 143
Contact Details ...........................................................144