Dynapac SD2500W - Setting menu 602 - screed type selection; Setting menu 603 - screed heater system

D 20 15
Setting menu 602 -
screed type selection
Menu for setting the
screed type.
- (1) screed type display and
adjustment parameters
- screed type Vario (V):
parameter 1
- screed type Rigid (R):
parameter 2
- (2) Heating type display
and adjustment parame-
ters
- Electric heater:
parameter 1
- Gas heater: parameter 2
A
If a different screed type has been connected to the paver finisher, the corresponding
setting must be carried out!
Setting menu 603 -
screed heater system
Menu for setting the screed
heater system:
- (1) nominal screed heater
system temperature (°C)
display and adjustment pa-
rameters
- (2) actual temperature,
left-hand main screed (°C)
- (3) actual temperature,
right-hand main
screed (°C)
- (4) actual temperature,
left-hand extendable part + extension parts (°C)
- (5) actual temperature, right-hand extendable part + extension parts (°C)
A
Setting range 0-180°C
A
All changes will be taken over to the other input devices (remote control, control box
of screed heating).
Only when equipped with E-heating:
- (6) Number of actual heatet screed sections
1
2
4 5
2 3
1
6