E 13 39
5.4 Aligning the auger
- Loosen lock nuts (26).
A
Note the left-hand thread (L) and right-hand thread (R) mark on the brace!
- Extend or shorten the braces (14) by rotating both adjustment rods (18) until all
mounted guides and auger segments are in line.
A
The adjustment rod (18) is equipped with a bore (27) on the left and right. A suitable
drift can be used to adjust the length of the adjustment rod here. The rotational direc-
tion for extending or shortening the adjustment rod is determined by the left-hand
thread (L) or right-hand thread (R).
A
A cord which aligns with the screed or the rear panel of the vehicle can be used e.g.
to provide assistance during alignment!
- Extend the upper and lower adjustment rods until the guides and auger segments
are aligned vertically.
- Retighten the lock nuts (26).
- Align the auger height in the same way by adjusting the vertical brace (21).
A
Check the horizontal alignment with a spirit level!
To Next Page
Loading...
Need help?
General
