EasyManuals Logo

Dynapac SD2500W User Manual

Dynapac SD2500W
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #259 background imageLoading...
Page #259 background image
D 43 15
1.2 Preparation for transportation
m
Transportation is only permitted with the driver sitting on the left as this is the side with
the service brake pedal!
- Close the hopper with switch (36)/(37).
- Engage both hopper transport safeguards.
- Lift the screed completely using switch (68), set the crossbeam lock.
- Turn the travel drive preselector (15) to zero.
- Activate set-up mode function (65).
- Fully extend the levelling cylinders with switch (56),(58)/(59).
A
To extend the levelling cylinders, levelling operating mode (126)/(130) must be
switched to "MANUAL" (LED OFF) on the remote controls.
- Use switch (42)/(43) to adjust the screed to the basic width of the paver finisher.
m
Lift the auger if necessary!
A
If the engine is started with the drive lever pivoted out, the travel drive is inhibited.
To start the travel drive, first the drive lever must be returned to the centre position.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac SD2500W and is the answer not in the manual?

Dynapac SD2500W Specifications

General IconGeneral
BrandDynapac
ModelSD2500W
CategoryConstruction Equipment
LanguageEnglish

Related product manuals