F 100 3
2 General visual inspection
The daily routine should comprise a visual inspection around the entire paver finisher.
The following items must be checked:
- Are components or controls damaged?
- Are there leaks on the engine, the hydraulics, the gearbox, etc.?
- Are all fastening points (conveyor, auger, screed, etc.) in order?
m
Immediately take actions to correct any detected malfunction to avoid damages, dan-
gers or environmental hazards!
3 Inspection by an expert
A
Have finisher, screed and optional gas or electric system checked by a trained spe-
cialist
- when required (according to the operating conditions and the nature of application),
- however, at least once a year, check that they are all in good operational condition.
To Next Page
Loading...
