D 43 5
1.1 Starting the paver finisher
Before starting the paver finisher
Before starting the diesel engine and beginning operation, the following steps must
be performed:
- Daily maintenance of the paver finisher (see chapter F).
m
Check the operating hours counter to determine whether further maintenance work
should be conducted.
- Check the safety devices and protective devices.
"Normal" starting
- Set the drive lever (13) to the centre position and the travel drive preselector (15) to
minimum.
- Insert the ignition key (11) in position "0".
m
The lights should be switched off during starting to reduce the current drain on the
battery.
A
It is impossible to start the vehicle if an emergency stop button (10) / (120) is de-
pressed.
(Error shown on the display)
- Press the starter button (12) to start the engine. Do not let the starter run perma-
nently for more than 30 seconds; allow for a break of 2 minutes after every attempt!
To Next Page
Loading...
