EasyManuals Logo

Dynapac SD2500W User Manual

Dynapac SD2500W
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #255 background imageLoading...
Page #255 background image
D 43 11
Observe indicator lamps
The following indicator lamps must be observed under all circumstances:
For further possible faults, refer to the Engine operating instructions.
Engine coolant temperature check (79)
Lights up when the engine temperature is outside of the permissible range.
m
Stop the paver finisher (drive lever to the centre position), let the engine cool down
while idling.
Determine the cause and correct it if necessary.
A
The engine performance will be throttled down automatically. (Driving mode remains
possible).
After cooling down to normal temperature, the engine will run with full performance
again.
Battery charge indicator (83)
Must go out after starting when the engine revs up.
m
If the lamp does not go out or lights up during operation: Briefly rev up the engine.
Switch off the engine and determine the fault if the lamp does not go out.
For further possible malfunctions, refer to the section "Malfunctions".
Oil pressure indicator lamp for the diesel engine (86)
Must go out at the latest 15 seconds after starting.
m
If the lamp does not go out or lights up during operation: switch off engine immediately
and determine fault.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac SD2500W and is the answer not in the manual?

Dynapac SD2500W Specifications

General IconGeneral
BrandDynapac
ModelSD2500W
CategoryConstruction Equipment
LanguageEnglish

Related product manuals