D 43 17
Driving and stopping the paver finisher
- Set the Fast/Slow switch (72) to "Hare".
- Set the preselector (15) to mark 10.
- For driving, carefully tilt the drive lever (13) forward or backward according to the
drive direction desired.
- Adjust the speed with the preselector (15).
- Carry out steering movements with the steering wheel (16).
f
In case of an emergency, press the emergency stop button (10)!
- To stop, press the service brake (A), set the preselector (15) to "0" and move the
drive lever (13) into its centre position.
A
If the vehicle was brought to a standstill with the service brake, it cannot be driven
away again until after the drive lever has been put into neutral!
To Next Page
Loading...
